31-08-2003, 01:54am
For those who are like me and do not like to "cut" plastics to mount switches etc....
I mounted an on/off toggle switch in the left switch assembly.
You can use the switch for what every you want, however I use the left one to control my accessory lighting.... (Neons). Took about 20 min. to instal. See pics below..
Got toggle switch from radio shack. The rubber seal cover has a nut built into it. Also from radio shack. Remove three screws on bottom of switch assembly. The switch assembly removes in two halves. Eyeball from inside first. Mark drill hole for toggle part of switch to extend through in switch assembly top half. Solder wires to toggle switch and route along factory wires leaving assembly and under left inner panel.
Insert toggle into position. slide rubber seal over toggle and tighten nut. reassemble two halves back on bike. Connect to what ever. Looks clean. Easy to reach with thumb. I soldered my connections to the switch prior to installing into the space. I found this mod sufin sights but it works very well.
For those who do not want to order the right switch assembly with the on/off headlight switch built in, this is an alternative.
ICEMANN
<i></i>
I mounted an on/off toggle switch in the left switch assembly.
You can use the switch for what every you want, however I use the left one to control my accessory lighting.... (Neons). Took about 20 min. to instal. See pics below..
Got toggle switch from radio shack. The rubber seal cover has a nut built into it. Also from radio shack. Remove three screws on bottom of switch assembly. The switch assembly removes in two halves. Eyeball from inside first. Mark drill hole for toggle part of switch to extend through in switch assembly top half. Solder wires to toggle switch and route along factory wires leaving assembly and under left inner panel.
Insert toggle into position. slide rubber seal over toggle and tighten nut. reassemble two halves back on bike. Connect to what ever. Looks clean. Easy to reach with thumb. I soldered my connections to the switch prior to installing into the space. I found this mod sufin sights but it works very well.
For those who do not want to order the right switch assembly with the on/off headlight switch built in, this is an alternative.
ICEMANN
<i></i>