Place A Quick Shifter

[Fester]

Hi everyone.

Here are some pictures.
Placement 4-114 Dynojet Quick Shifter on to original wiring.

1) Wiring is opened to interrupt the MS2 Wire - Oranje/rood-1 green dot.
2) The wire of the switch boot will become isolated.
3) The other wire goes to the outside to be connected to the Quick shifter.
4) Then black / white wire something dismantled and there become a soldered wire, which is the Gnd it is also connected to the quick shifter.

Note:
ABC switch modus for engine managment dont work anymore
This work is now only programmed via USB ECU inteface Woolrich Racing through the ECU of the motorcycle.

[Fester]

The QiuckShifter from DynoJet 4-114 puch work not.
The Dynojet is a Nc contact.
Now I took another quick shifter with No contact now run all.
Just I have to adjust it via the ECU

[dad1300]

[quote='Fester' pid='289910' dateline='1379753320']
Hi everyone.
Here are some pictures.
Placement 4-114 Dynojet Quick Shifter on to original wiring.


Hi Fester, I'm awaiting an Akra 4:1/PC5/SFM package so can you advise me what length the Dynojet QS Sensor is?

That will give me a length to start getting an appropriate length Shift Rod.

Cheers

dad1300