Login

**piperjon** · (This post was last modified: 15-09-2011, 06:58pm by piperjon.)

Hi Guy's.

Just a question. how do the rear rotor fit on the rear wheel??
Are they pressed on??
I have to replace the rotor on my K8 and was wounding how they are fitted.

15-09-2011, 07:17pm

Bolted

**pan** · (This post was last modified: 15-09-2011, 09:30pm by pan.)

Remove bolts,clean surface (get rid of any brake dust and make sure it's smooth, then apply a little bit of loctite on bolts.

I'm good with brakes!

**piperjon** · (This post was last modified: 15-09-2011, 09:44pm by piperjon.)

Thanks Pan,

I looked at the rotor and couldn't see any bolts, but they must be there some where I'll find them. Thanks again. John

My EBC rotor.

.jpg

ebc_contour_xc_busa_200_rear.jpg (Size: 12.14 KB / Downloads: 51)

(15-09-2011, 07:17pm)BLACKZOOK Wrote: Bolted

Thanks BLACKZOOK.
John

**pan** · 15-09-2011, 09:46pm

The bolts are holding your old rotor onto the wheel at the moment. Just use the ones that are already on the bike (or buy titanium ones off eBay and repace them)

Login
Username:
Password:	Lost Password?
	Remember me