Verlosity stacks
#1
Just after your opinions on what stacks you use and if anyone has got info on which stacks are best for a Genll for 1- torque and 2- HP.

I've read some threads but want some deeper info than they offer-personal preference/written info if poss.

Cheers.
Reply
#2
http://www.hayabusa.org/forum/gen-ii-bus...tacks.html
"casting dispersions on others credability." And their illiteracy.
Reply
#3
(28-01-2011, 11:12am)Rainbow7 Wrote: http://www.hayabusa.org/forum/gen-ii-bus...tacks.html

Thanks bud.
Reply
#4
Tongue 
Bin that idea. Anyone know who is best for cnc porting and flow testing heads in vic guys?
Reply
#5
Try contacting Phil Tainton Racing.
500 Stud Road, Wantirna South
Ph: 9801-1287

www.ptr.com.au
Reply
#6
Thanks Bikerboy. Will do.
Reply
#7
Dont get too caught up with the cnc part. CNC only ensures repeatability, not quality. The ports are ported by hand then digitised to create the cutter paths. If the initial porting that was digitised was crap, then the cnc machined ports will also be crap.
I pity the fool who goes out tryin' a' take over da world, then runs home cryin' to his momma!
Reply
#8
Thanks for the info Drworm.
Reply
#9
(28-01-2011, 04:45pm)drworm Wrote: Dont get too caught up with the cnc part. CNC only ensures repeatability, not quality. The ports are ported by hand then digitised to create the cutter paths. If the initial porting that was digitised was crap, then the cnc machined ports will also be crap.

Though I am after repeatability of intake length...
Reply




Users browsing this thread: 2 Guest(s)