Clutch Setting for Busa

[Bill Gaheer]

HI,

Just installed new Clutch, today I noticed that when the bike is not ON and I put it in gear it seems that bike is engaged in gear and wont move ahead even with lever completely depressed.
It works fine when the bike is turned on - it moves on half clutch (but noticed a shudder)

What am I missing?

Question 2>
I have ordered Starter clutch, do we have any existing post on DIY on replacing Starter clutch.

Cheers,

Bill

[spamanglenn]

just the oil on the fibres and if it shudders maybe a couple of warped steels.Also check if you put the cushion ring back in properly.

[Bill Gaheer]

just the oil on the fibres and if it shudders maybe a couple of warped steels.Also check if you put the cushion ring back in properly.

Hi Spamanglenn,

The fiber were dipped in Oil for good 24 hours. Steel Plates looked fine - I have a working clutch which I replaced.

I coundnt understand "check if you put the cushion ring back in properly' - my be if you can explain a bit it would help.

cheers,

Bill

[Maj]

New plates may drag a litle till run in, had a set of non oem plates do that to me once before, actually dragging me through the lights at the drags, put them on the shelf and there still there 2 yrs later..