Sub-frame break - Printable Version +- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB) +-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35) +--- Forum: General Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=1) +--- Thread: Sub-frame break (/showthread.php?tid=6003) |
Sub-frame break - Volvi - 17-07-2000 In anticipation that this board will be off and running in a few days, I will start this topic as raised by Peter with the pics showing the break. Just amazing, I have heared about a break in the main weld as experienced by our Melbournian 'copper' (police) guy who rides his black/red into the ground (also responsible for the cam chain recall). Have heared that he's recovering from a bad fall, whilst totalling his bike, and blames the weld-break. However I believe he may have been performing some Busa 'acrobatics' at the time. Re: Sub-frame break - demeester - 17-07-2000 I have contacted Suzuki Australia and am awaiting a reply on an official stance. Action motorcycles (Melbourne) knew nothing about it until I talked to them, and they are going to investigate. Apparently the TL1000 and other models have suffered from this problem. Sub Frame Breakage - Darren - 20-07-2000 Anyone else got any news on the sub frame breakage. I often carry a pillion but won't be until i hear further news on the topic. Re: Sub Frame Breakage - demeester - 20-07-2000 I continue to carry pillions (only one at a time ), and once a week, inspect for potential problems. Proportionally, the number of incidents is low, but it is still worth being aware - just not paranoid. Sub Frame Breakage - Darren - 20-07-2000 Thanks for the feedback, when I saw the photos posted of the damage, I had a mental picture of a pillion skinning their arse on the rear tyre "ouch". Re: Sub Frame Breakage - Fox - 20-07-2000 Does anyone know how many Ks these bikes have done? I'm assuming (maybe incorrectly) it would take a few Ks before the split. |