Chrome Button Caps - Printable Version +- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB) +-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35) +--- Forum: General Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=1) +--- Thread: Chrome Button Caps (/showthread.php?tid=23346)

Chrome Button Caps - gmb - 08-12-2016 Hi All I am trying to fit bar risers, because the body is getting older. I am having problems in removing the chrome caps on top of the bolts. Can anyone explain to me how to remove them. Thanks Glen RE: Chrome Button Caps - Batfink - 08-12-2016 If you are talking the 4 bolts that hold the handle bar bracket on top of triple then there are no caps. Its a fluted bolt whcih means a nut and thread one side and pin head with fluted grooves down the side on the other (top side). I found then a real bitch to try to undo on my 99. In the end I wedged in a small screwdriver between bracket and bolt head and used the drive on impact mode to loosen nut. RE: Chrome Button Caps - gmb - 08-12-2016 Thanks Batfink That worked well RE: Chrome Button Caps - TheShredder - 13-12-2016 The 4 bolts do have chrome caps just stick a knife blade or small flat blade screw driver under the edge of it to lever them up & out Then use the correct allen key to hold the head while you undo the nut below this helps to do them up again RE: Chrome Button Caps - Ward P - 26-12-2016 RE: Chrome Button Caps - gmb - 27-12-2016 Thanks I did have a closer look after removing one. A fine blade worked for me. Cheers Glen