+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Hayabusa Exhausts (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=11)
+--- Thread: Gen1 Exhaust -> Gen2 bike (/showthread.php?tid=22027)
Gen1 Exhaust -> Gen2 bike - Zrex1200 - 27-08-2014
Ok, had look through this thread & can't find a definitive answer.
The seller of the 2nd hand full system (Micron) I am looking at tells me it is off a Gen1 & will fit a Gen2.
Can anyone confirm this for me please?
Thanks in advance.
RE: Gen1 Exhaust -> Gen2 bike - big kev - 28-08-2014
Check your header sizeing before you go any further ok I know the system your going to buy
RE: Gen1 Exhaust -> Gen2 bike - PostmanPete - 28-08-2014
(28-08-2014, 05:26am)big kev Wrote: Check your header sizeing before you go any further ok I know the system your going to buy
The header pipe from my Gen 1 bolted straight onto my Gen 2!!
RE: Gen1 Exhaust -> Gen2 bike - simmo - 28-08-2014
Gen 1 will fit a Gen 2 the only difference is the bracket under the back of the motor is in different position, on my system Gen 2 it does not have that mounting point anyway, so yes you can fit it with out the rear mount
RE: Gen1 Exhaust -> Gen2 bike - Zrex1200 - 29-08-2014
Thanks all, that backs up the info I have, much appreciated.
Kev, Is there a difference specific to the Micron systems?