+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Hayabusa Gen.II (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=45)
+--- Thread: Removing header gaskets (/showthread.php?tid=21373)
Removing header gaskets - jamie - 23-01-2014
Hey guys, I'm replacing my header gaskets after recently fitting a wideband to my exhaust. After looking at the exhaust port, for me its hard to tell what the gasket looks like. I dont wanna start sticking a flathead screwdriver in there if i don't know where to start prying. Any ideas how to get them out? Shouldn't be hard, the bikes' only 4 months old.
Many thanks
RE: Removing header gaskets - GRUNTMAX - 23-01-2014
Here's a bald one so ya know what ya digging at.
Try a fitter's Scriber. Sometimes they just fall out.
......................next time; http://www.competitioncnc.com/products.html
....should be good for the Supercharged Stroker
