+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: Lost Instros? (/showthread.php?tid=18379)
Lost Instros? - Bartman - 29-12-2011
Just on my way tonight to work when all instruments died on the dash? have nothing no odo, tacho,speedo,fuel,temp or any indicators or tail light, have headlight and the bike will run and starts again if I switch it off. Im suspecting a fuse are the fuses under the left fairing side dash panel as on Gen2s? will get out later and have a look.
Cheers Bartman
RE: Lost Instros? - pan - 29-12-2011
Yep, fuses are on under the left panel... when you remove the panel, run your hand behind the instrument cluster too and make sure the loom is plugged in properly (it should "click" into position)
RE: Lost Instros? - Bartman - 29-12-2011
(29-12-2011, 08:00pm)pan Wrote: Yep, fuses are on under the left panel... when you remove the panel, run your hand behind the instrument cluster too and make sure the loom is plugged in properly (it should "click" into position)
Cheers mate will let you all know how I go.
Bartman
RE: Lost Instros? - Axe - 29-12-2011
A little while back I bottomed out and tore the number plate light wire, and that then blue the fuse for the dash....
Possible cause?????
RE: Lost Instros? - Bartman - 29-12-2011
All good boys was a blown fuse, the label on the lid said it should be 15a but the fuse in the space was 10a so have replaced with one of the spares and all good, thanks for the quick replies. Cheers Bartman
(29-12-2011, 08:36pm)Axe Wrote: A little while back I bottomed out and tore the number plate light wire, and that then blue the fuse for the dash....
Possible cause?????
What were you doing Ash to bottom out???? This bike was also just relicenced and it used to have the integrated indicators/tail light set up but this is no good for licencing so the dealer put indicators and plate light on it there was a couple of loose open ended wires under the tail hump from the original set up I have just tied them apart and will tape over the ends when Im on days off. Yey mate how is it going with Ryans rebuild, He is down for the track day I see?? Cant wait!!!
Bartman.