+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: Kaneg Headlift stand (/showthread.php?tid=16069)
Kaneg Headlift stand - Pommie - 27-10-2010
I just bought one of these little beauties after a bit of a dodgy escapade with a bottle jack. Anyway, lifted the old girl up great, but couldnt get it off the stand without lifting it up a little on the jack again. Anyone else had an issue like this ??
RE: Kaneg Headlift stand - pan - 27-10-2010
Yeh, the headlift stands seem to rub or put pressure at the bottom end/front of the nosecone... They all do it.
RE: Kaneg Headlift stand - CarbonBusa - 27-10-2010
Run the front wheel up on a bit of wood first & it will give you a little more clearance/angle & not rub on the nose
RE: Kaneg Headlift stand - Pommie - 27-10-2010
It wasn't rubbing on the nose so much as couldn't get the pin out of the head until I lifted it a little under the sump. The wood should work okay though
RE: Kaneg Headlift stand - CarbonBusa - 27-10-2010
(27-10-2010, 09:17pm)Pommie Wrote: It wasn't rubbing on the nose so much as couldn't get the pin out of the head until I lifted it a little under the sump. The wood should work okay thoughYeah the wood gives you a better angle to work with but still tricky.