![]() |
Looking for a Supplier - BST Carbon - Printable Version +- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB) +-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35) +--- Forum: General Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=1) +--- Thread: Looking for a Supplier - BST Carbon (/showthread.php?tid=14485) |
Looking for a Supplier - BST Carbon - BikerBoy - 13-02-2010 I'm finaly getting my Busa in a couple of weeks, and I've decided my first mod will be a set of BST Carbon wheels with ceramic bearings. I was going to keep my current bike (K9 GSX650F) and have the two but I just figured if I sell it I can use that cash for the wheels and a few bits and peices. Is anyone on the forum a supplier or know of a good one for BST Wheels? The only one I have found is http://www.gorillazilla.com.au/products/cat/20 Cheers. Paul RE: Looking for a Supplier - BST Carbon - Macbusa - 13-02-2010 WOW ![]() ![]() I don't know anyone off the top of my head that has them. Make sure you post some pics up when they are fitted ![]() RE: Looking for a Supplier - BST Carbon - BLACKZOOK - 13-02-2010 BB check out this thread http://nswroadandtrackbikes.com/forums/showthread.php?14421-Great-bst-wheels-news!!!!!!!!!!!!!!!!!!!!!!!! He is the Aussy distributor and has a special running at the moment. $3999.00 for any bike. These are the wheels I wanted to buy if I could sell my Galespeeds. He quoted me an extra $70.00 for the 6 3/4" rear. With 4 week lead time. Good luck. RE: Looking for a Supplier - BST Carbon - BikerBoy - 13-02-2010 Thanks for the info Bruce. That's a pretty good deal. Can't get into the link without registering first though and that stupid car race question tells me I'm wrong every time. RE: Looking for a Supplier - BST Carbon - LOAFIE - 13-02-2010 Hope this helps www.rocketbikes.com.au RE: Looking for a Supplier - BST Carbon - BikerBoy - 13-02-2010 That's what I'm after. Thanks Guys |