+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: Extending wiring loom (/showthread.php?tid=14219)
Extending wiring loom - [UNIT] - 07-01-2010
Hi
I'm extending my wiring loom to the tip over sensor, air pressure sensor, starter solenoid (not + -) and everything else under the seat!
What guage cable should I be looking for? I don't want to do it by eye as the insulation can vary.
Cheers
RE: Extending wiring loom - Legend - 07-01-2010
Strip back the insulation, the do it by eye....
The sensors shouldn't matter if its a bit thiner or thicker, but as for the start solinoid I'd remove the wire and take it with you, go for a slighty thicker wire if your extending it a significant lenght.
Some of the better electronic shops should carry what your after, except for the colours....
Leonard.
RE: Extending wiring loom - [UNIT] - 07-01-2010
Thanks mate. I'll do that.
Had an idea about chasing looms thru wreckers. I'm sure most of Suzuki use similar plugs. That way I won't change the STD loom. Probably safer
RE: Extending wiring loom - Camel - 07-01-2010
Don't restrict yourself to Busa looms! I've found many late model zooks run the same wires, plugs and even miscellaneous components - like starter relays, TOS, etc. Even scooters!