Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED
brake union bolt tension w/ copper crush wash - Printable Version

+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: brake union bolt tension w/ copper crush wash (/showthread.php?tid=10006)



brake union bolt tension w/ copper crush wash - Monyx - 01-06-2008

Would you make an allowance for (softer) copper crush washers and go a bit higher tension on the brake union bolt, up from the 16.5 ft lbs?
Mark


RE: brake union bolt tension w/ copper crush wash - Legend - 01-06-2008

Tighten it up the same!

Leonard.Biker